计算 · 学习 · 标准
Indoor Environmental Quality / 室内环境质量

Air Quality Testing and Monitoring

空气质量测试与监测
EQc5 Credit
EN

— AIR QUALITY TESTING AND MONITORING EQc5 1–4 points

CN

空气质量测试与监测 EQc5 1–4 分

Intent / 意图

EN

To support better management of IAQ and identify opportunities for health-based approaches to building operations.

CN

支持更好的 IAQ 管理,识别以健康为导向的运营机会。

Requirements / 要求

EN

Achievement Pathways Points Commercial Interiors 1–4

CN

达标路径 分值 商业室内 1–4

EN

Option 1. Pre-Occupancy Air Testing 1–2

CN

选项 1. 入住前空气测试 1–2

EN

Path 1. Particulate Matter and Inorganic Gases 1 AND/OR

CN

路径 1. 颗粒物与无机气体 1

EN

Path 2. Volatile Organic Compounds 1

CN

和/或 路径 2. 挥发性有机化合物 1

EN

AND/OR

CN

和/或 选项 2. 连续室内空气质量监测 1

EN

Option 2. Continuous Indoor Air Monitoring 1

CN

选项 1. 入住前空气测试(1–2 分)

EN

Option 1. Pre-Occupancy Air Testing (1– 2 points) After construction ends and before occupancy, but under ventilation conditions typical for occupancy, conduct baseline IAQ testing. Retail projects may conduct the testing within 14 days of occupancy. The number of measurements should be specified according to Table 1 and taken in respective locations of the building.

CN

施工结束后、入住前,在典型入住通风条件下开展基线 IAQ 测试。零售项目可在入住 14 天内测试。测量数量按表 1 指定,在相应位置进行。

EN

Table 1. Number of Measurements Required for Preoccupancy Air Testing Total Occupied Floor Area, sq. ft (sq. m.) Number of Measurements ≤ 5,000 (500) 1 > 5,000 (500) and ≤ 15,000 (1,500) 2 > 15,000 (1,500) and ≤ 25,000 (2,500) 3 > 25,000 (2,500) and ≤ 200,000 (20,000) 4 plus one additional measurement per each 25,000 sq. ft. (2,500 sq. m.) above 25,000 sq. ft. Total Occupied Floor Area, sq. ft (sq. m.) Number of Measurements > 200,000 (20,000) 10 plus one additional measurement per each 50,000 sq. ft. (4,600 sq. m.) above 200,000 sq. ft. PATH 1. PARTICULATE MATTER AND INORGANIC GASES (1 POINT) Test for the particulate matter (PM) and inorganic gases listed in Table 2, using an allowed test method, and demonstrate that the contaminants do not exceed the concentration limits listed in the table. Measure for a four-hour period, and calculate theing peak concentration for carbon monoxide and average concentration for ozone, PM2.5, and PM10.

CN

表 1. 入住前空气测试所需测量数

EN

Table 2. Limits for Particulate Matter and Inorganic Gases Contaminant (CAS#) Concentration Limit (µg/m3) Allowed Test Methods (laboratory-based) Direct Reading Instrument Minimum Specifications Carbon monoxide (CO) 9 ppm; no more than 2 ppm above outdoor levels ISO 4224 EPA Compendium Method IP-3 GB/T 18883-2002 for projects in China Direct calibrated electrochemical instrument with accuracy of ± 3% of reading and resolution of 0.1 ppm NDIR CO sensors with accuracy of 1% of 10 ppm full scale and display resolution of less than 0.1 ppm Particulates (for projects in attainment areas) ISO class 8 or lower per ISO 14644-1:2015 OR meet PM10: 50 μg/m 3 PM2.5: 12 μg/m3 n/a Accuracy (±): Greater of 5 μg/m3 or 20% of reading Resolution (±): 5 μg/m3 IP-10A Particulates (for projects in nonattainment areas) ISO class 8 or lower per ISO 14644-1:2015 OR meet PM10: 50 μg/m 3 PM2.5: 35 μg/m3 n/a Accuracy (±): Greater of 5 μg/m3 or 20% of reading Resolution (±): 5 μg/m3 IP-10A Contaminant (CAS#) Concentration Limit (µg/m3) Allowed Test Methods (laboratory-based) Direct Reading Instrument Minimum Specifications Ozone 0.07 ppm OR 0.01 ppm for projects pursuing EQc1: Enhanced Air Quality, Option 1, Path 2 ISO 13964 ASTM D5149-02 EPA-designated methods for ozone Monitoring device with accuracy greater of 5 ppb or 20% of reading and resolution (5 min average data) ± 5 ppb Note: ppm = parts per million; ppb = parts per billion. AND/OR PATH 2. VOLATILE ORGANIC COMPOUNDS (1 POINT)

CN

总占用楼面面积 测量数

EN

Table 3. Volatile Organic Compound Limits Contaminant (CAS#) Concentration Limit (µg/m3) Allowed Test Methods Formaldehyde 50-00-0 20 µg/m3 (16 ppb) ISO 16000-3, 4; EPA TO-11a; EPA comp. IP-6A; ASTM D5197-16 Acetaldehyde 75-07-0 140 µg/m3 Benzene 71-43-2 3 µg/m3 ISO 16000-6; EPA IP-1; EPA TO-17; EPA TO-15; ISO 16017-1, 2; ASTM D6196-15 Hexane (n-) 110-54-3 7,000 µg/m3 Naphthalene 91-20-3 9 µg/m3 Phenol 108-95-2 200 µg/m3 Styrene 100-42-5 900 µg/m3 Tetrachloroethylene 127-18-4 35 µg/m3 Toluene 108-88-3 300 µg/m3 Vinyl acetate 108-05-4 200 µg/m3 Dichlorobenzene (1,4-) 106-46-7 800 µg/m3 Xylenes— total 108-38-3, 95-47-6, and 106-42-3 700 µg/m3

CN

≤5,000 sq. ft.(500 m²) 1

EN

AND/OR

CN

>5,000(500)且 ≤15,000(1,500) 2

EN

Option 2. Continuous Indoor Air Monitoring (1 point) Provide indoor air monitors for all of the following parameters:

CN

>15,000(1,500)且 ≤25,000(2,500) 3

EN

• Perform a screening test for total volatile organic compounds (TVOC). Use ISO 16000-6, EPA TO-17, or EPA TO-15 to collect and analyze the air sample. Calculate the TVOC value per EN 16516:2017; California Department of Public Health Standard Method v1.2 2017, Section 3.9.4; or an alternative calculation method, as long as the full method description is included in the test report. o If the TVOC levels exceed 500 µg/m3, investigate for potential issues by comparing the individual VOC levels from the gas chromatography-mass spectrometry (GC/MS) results to associated cognizant authority health-based limits. Correct any identified issues and retest if necessary.

CN

>25,000(2,500)且 ≤200,000(20,000) 4,且每超出 25,000 sq. ft.(2,500 m²)加 1

EN

• Test for the individual VOCs listed in Table 3 using an allowed test method and demonstrate that the contaminants do not exceed the concentration limits listed in the table. Laboratories that conduct the tests must be accredited under ISO/IEC 17025 for the test methods they use.

CN

>200,000(20,000) 10,且每超出 50,000 sq. ft.(4,600 m²)加 1

EN

• Carbon dioxide (CO2)

CN

路径 1. 颗粒物与无机气体(1 分)

EN

• Particulate matter (PM2.5)

CN

采用允许测试方法测试表 2 所列颗粒物与无机气体,证明污染物不超过表列浓度限值。测量 4 小时,一氧化碳计峰值浓度,臭氧、PM2.5、PM10 计平均浓度。

EN

• Total volatile organic compounds (TVOC)

CN

表 2. 颗粒物与无机气体限值(摘)

EN

• Temperature

CN

污染物 浓度限值(µg/m³) 允许测试方法(实验室) 直读仪器最低规格

EN

• Relative humidity Monitors must be building grade or better and located between 3 and 6 feet (1–2 meters) above the floor.

CN

一氧化碳(CO) 9 ppm;不高于室外 2 ppm ISO 4224、EPA Compendium IP-3、中国项目可用 GB/T 18883-2002 直校电化学,精度 ±3% 读数、分辨率 0.1 ppm;NDIR CO 传感器精度 1% of 10 ppm 满量程、显示分辨率 <0.1 ppm

EN

 

CN

颗粒物(达标区) ISO class 8 或更低,或 PM10 50 µg/m³、PM2.5 12 µg/m³ — 精度 ±max(5 µg/m³, 20% 读数),分辨率 ±5 µg/m³

EN

 

CN

颗粒物(非达标区) ISO class 8 或更低,或 PM10 50 µg/m³、PM2.5 35 µg/m³ — 同上

EN

 

CN

臭氧 0.07 ppm;追求 EQc1 选项 1 路径 2 时为 0.01 ppm ISO 13964、ASTM D5149-02、EPA 指定臭氧方法 精度 max(5 ppb, 20% 读数),分辨率 ±5 ppb

EN

 

CN

路径 2. 挥发性有机化合物(1 分)

EN

 

CN

• 开展总挥发性有机化合物(TVOC)筛查,采用 ISO 16000-6、EPA TO-17 或 TO-15 采集分析空气样品,按 EN 16516:2017 或 CDPH Standard Method v1.2-2017 第 3.9.4 节计算 TVOC 值(或含完整方法说明的替代算法)。若 TVOC 超 500 µg/m³,须对比 GC/MS 单项 VOC 与权威健康限值排查问题,必要时整改并复测。

EN

 

CN

• 测试表 3 所列单项 VOC,证明不超限值。实验室须按所用方法获 ISO/IEC 17025 认可。

EN

 

CN

表 3. 挥发性有机化合物限值(µg/m³)

EN

 

CN

甲醛 20(16 ppb);乙醛 140;苯 3;正己烷 7,000;萘 9;苯酚 200;苯乙烯 900;四氯乙烯 35;甲苯 300;醋酸乙烯酯 200;对二氯苯 800;二甲苯(总计)700。

EN

 

CN

和/或 选项 2. 连续室内空气质量监测(1 分)

EN

 

CN

为下列所有参数提供室内空气质量监测器:二氧化碳(CO2)、颗粒物(PM2.5)、总挥发性有机化合物(TVOC)、温度、相对湿度。监测器须建筑级或更好,位于地面上方 3–6 英尺(1–2 米)。

^ Resilient Spaces ← 工具箱 ← ID+C 首页 Project Priorities v v